Section 1 Safety Information
Please read this entire manual before operating this equipment. Pay attention to all danger, warning, and caution statements in
this manual. Failure to do so could result in serious personal injury or damage to the equipment.
Make sure that the protection provided by this equipment is not impaired. DO NOT use or install this equipment in any
manner other than that specified in the installation manual.
1.1 Potential Hazards:
Read all labels and tags attached to the system. Personal injury or damage to the system could occur if not observed.
This symbol indicates safety glasses with side protection is
required for protection against UV exposure.
This symbol indicates safety glasses with side protection is
required for protection against UV exposure.
This symbol indicates gloves must be worn.
Warning:
This product may contain chemicals known to the State of California to cause cancer and birth defects or other reproductive h arm.
1.2 Safety Precautions:
3
This symbol indicates safety boots must be worn.
This symbol indicates the operator must read all available docu-
mentation to perform required procedures.
This symbol indicates the plumber must use copper piping.
This symbol indicates that the system should only be connected
to a properly grounded, grounding-type controller receptacle that
is protected by a Ground Fault Circuit Interrupter (GFCI).
Waste electrical and electronic equipment (WEEE). This symbol indicates that
you should not discard wasted electrical or electronic equipment (WEEE) in the
trash. For proper disposal, contact your material close to the system. local recy-
cling/reuse or hazardous waste center.
This symbol indicates not to store any combustible or flamma-
ble material close to the system.
This is the safety alert symbol. Obey all safety messages that follow
this symbol to avoid potential injury. When on the equipment, refer to
the Operational and Maintenance manual for additional safety
This symbol indicates a risk of electrical shock and/or electrocution
exists.
This symbol indicates the marked equipment may contain a compo-
nent that can eject forcibly. Obey all procedures to safely depressur-
ize.
This symbol indicates the system is under pressure.
This symbol indicates there is a potential UV hazard. Proper protec-
tion must be worn.
This symbol indicates the marked item could be hot and should not
be touched without care.
This symbol indicates there is a potential for VERY hot water when
flow is started.
This symbol indicates there is Mercury present.
Hg
Failure to follow these instructions will result in serious injury or death.
Electric Shock:
To avoid possible electric shock, special care should be taken since water is present near the electrical equipment. Unless a situation is encountered that is explicitly addressed by the
provided maintenance and troubleshooting sections, DO NOT attempt repairs yourself, refer to an authorized service facility.
GROUNDING:
This product must be grounded. If it should malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce the risk of electrical shock. This system is
equipped with a cord having an equipment-grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes
and ordinances.
Improper connection of the equipment-grounding conductor can result in a risk of electrocution. Check with a qualified electrician or service personnel if you are in doubt as to whether the outlet is
properly grounded. DO NOT modify the plug provided with this system - if it does not fit in the outlet, have a proper outlet installed by a qualified electrician. DO NOT use any type of adapter with this system.
GROUND FAULT CIRCUIT INTERRUPTER PROTECTION
:
To comply with the National Electrical Code (NFPA 70) and to provide additional protection from the risk of electric shock, this
system should only be connected to a properly grounded, grounding-type controller receptacle that is protected by a Ground Fault Circuit Interrupter (GFCI). Inspect operation of GFCI as per manufacturer's suggest-
ed maintenance schedule.
DO NOT
operate the disinfection system if it has a damaged cord or plug, if it is malfunctioning or if it has been dropped or damaged in any manner.
DO NOT
use this disinfection system for other than intended use (potable water applications). The use of attachments not recommended or sold by the manufacturer / distributor may cause an unsafe condition.
DO NOT
install this disinfection system where it will be exposed to the weather or to temperatures below freezing.
DO NOT
store this disinfection system where it will be exposed to the weather.
DO NOT
store this disinfection system where it will be exposed to temperatures below freezing unless all water has been drained from it and the water supply has been disconnected.
