US Praxis PRX130, Owner'S Manual

Page: 22 / 49

US Praxis, Inc. – Copyright 2009 © All rights reserved
22
­Continued­
14. Turn throttle to the (START)DISENGAGE position, wait ten seconds for blade to stop
rotating then release brake and retract
machine from stump.
15. Pull machine away from stump, and rake
chips away from stump.
16. Place stump machine into position with
cutting blade near the front­top edge of
the stump.
17. Set brake to lock position.
18. Move throttle up to the ENGAGE position.
19. Complete cutting stump by repeating step 12 again and again until entire stump is cut to
desired depth.
20. Stop the machine.
Normal shutdown
Throttle
Set the throttle to SLOW/DISENGAGE.
If the engine has been running full out, let it run easily
for about 30 seconds to one minute at low speed.
DO NOT let front of unit touch ground until you are
sure cutting wheel has stopped turning.
A rotating cutting blade is very DANGEROUS!
Stay at the operating position and be sure that the blade comes to a complete stop before doing
anything else.