URYU UBX-AF Series, Instruction Manual

Page: 23 / 26

NOK Judgement LED tube
When an error occurs, OK / NOK Judgement LED tube flashes in red.
Please check the error display on UEC-4800 controller / UCC-100Z coordinator.
・
Error List (Display type shows Error on the monitor screen.)
Error Display Content Reference / Measure(s)
ZERO ERROR ERR01
Controller display :
ZERO check error at start up by grip switch
CAL ERROR ERR02
Controller display :
CAL check error at start-up by grip switch
SETUP ERROR ERR03
Controller display :
Setting range interlocking
TORQUE LOW TRQNOK (
＋
Value)
Torque Value
<
Torque Low
TORQUE HIGH TRQNOK (
＋
Value)
Torque Value
>
Torque High
PULSE LOW PLSNOK (
＋
Value) Pulse Count < Pulse Low
PULSE HIGH PLSNOK (
＋
Value) Pulse Count > Pulse High
FREE RUN ERROR
NOKFRE (
＋
Value)
Free Run Angle Value < Free Run Angle
ANGLE LOW DEGNOK (
＋
Value) Angle Value < Angle Low
ANGLE HIGH DEGNOK (
＋
Value) Angle Value > Angle High
INITIAL ERROR Elapsed time from START to CUT is shorter than
Initial Error Timer.
(Torque reaches CUT before Initial Error timer is
up.)
●
Double hit error
●
If the error appears with the
normal tightening process, review
setting parameters.
CYCLE ERROR Elapsed time from START to CUT is longer than
Cycle Error Timer.
(Torque does not reach CUT before Cycle Error
timer is up.)
●
Review workpiece condition.
●
Review setting parameters.
INCOMPLETE JOB
ERROR
Tool stops tightening before reaching CUT torque.
(e.g. Fingers off from trigger while tightening)
●
Review Judgement Delay Timer
●
Check tool condition.
●
Do not release fingers from trigger
before tool stops automatically.
CPU ERROR ERR10
Controller display :
CPU Thermal Error
MOTOR ERROR ERR11, ERR32
Controller display :
Motor System Error
ZIGBEE ERROR ERR12
Controller display :
ZigBee Communication Error
SENSOR ERROR ERR13, ERR14
Controller display :
Sensor Communication Error
BATTERY ERROR ERR15
Controller display :
Over-discharged battery, Battery Thermal Error
21