Urschel COMITROL 1700, Instruction Manual

Page: 228 / 233

April, 2000
COMITROL PROCESSOR MODEL 1700
(APR 00)
January 1998 - The United States Department of Agriculture discontinued its Equipment Acceptance Program
in lieu of a processor based Hazard Analysis & Critical Control Point system. By ruling, all U.S.D.A., Meat & Poultry
Division approvals of equipment, including those of Urschel® machines, have been eliminated.
Pgs 20 & 2" cutting parts and feed assemblies are no longer available on new machines. Repair parts and
44–46 cutting heads are available for customers currently using 2" parts; contact the factory for more infor-
mation
Pgs 28 & 73 Amplifier 63737 replaces the control monitor. See pages A2–A5 of this addendum for information
on the amplifier.
Pgs 40 & 42 Oil mist lubricator assembly is no longer supplied with threaded port inserts.
NOTE: The lubricator settings for the air pressure gauge, oil feed rate and air by-pass adjustment
shown in this manual should also be applied to previously built machines containing the 63314 and
63646 oil mist lubricators.
Pg 55 See page A6 of this addendum for an important notice regarding the installation of 62126 and
62855 Spindle Assemblies.
Pgs 142–145 NOTE: Check the motor brake information plate attached to the brake. The parts list in the man-
ual is for the 87000 series brake. If the brake is an 87000 rev B, contact Urschel Laboratories for
replacement part information. Parts are not interchangeable between the 87000 and the 87000 rev
B brakes.
A1