UC1114 User Guide
18
4.5.1.3 IF Input
A command containing this IF condition will be triggered if the selected input changed according
to the specified option.
The user can setup multiple combinations; however, input 1 and input 2 must be activated before
action is taken.
The logic options available includes:
•
AND: ALL the selected signals become active or ANY selected signals become inactive
•
OR: ANY selected signals become active or ALL the selected signals become inactive
Then the user can choose from the following options:
•
Goes Active (Triggered on rising edge)
•
Goes Inactive (Triggered on falling edge)
•
Changes State (Triggered on rising or falling edge)
•
Is Active (Triggered on high level)
•
Is Inactive (Triggered on low level)
Thus, if the user chooses "Goes Active", then as soon as the specified input changes from inactive
to active, the command will be triggered. Also, it applies to the remaining options when the
preset conditions are met.
The user is also able to specify a "Continued time" for this command, which will not be allowed
to be triggered until it remains Active or Inactive longer than the time specified. Moreover, the
user can specify a "Lockout time" for this command. After the command has been triggered, it
will not be allowed to be triggered again until the time specified has elapsed.
When you set the time, you can choose the time unit:
msec: 0-86400000
sec: 0-86400
min: 0-1440
Only integers are allowed. You can't carry the decimal point.
Note
:
There are 3 single actions at most to be executed for a single trigger condition.
Summary of Contents for UC1114
Page 1: ......