2.2.1.11
Schedule
Select “
Schedule
” and press “
ENTER
” to access the programming menu shown below.
Figure 24: recording programming menu
The selected item is highlighted.
Press arrows “
"#
” to point the cursor to the various menu items.
Point the cursor to the required item and press “
ENTER
” to edit it. Use buttons “
!
” to change the available options for the
selected menu item.
Select “
CONFIRM
” and press “
ENTER
” to make the changes effective.
Select “
CANCEL
” and press “
ENTER
” to cancel the changes.
Press “
ESC
” to go back by one step.
Press “
ESC
” several times until the configuration window closes to quit the configuration menu.
IMPORTANT NOTE
"#
The device will resume recording only recording tasks programmed in the “
Registrazione
” menu after a
blackout. Recordings started manually will not be resumed after a blackout.
2.2.1.11.1
Day
This option is used to set and program recording on the selected camera for day of the week.
Use “
!
” to select.
This option can be used to set up to 4 recording periods for each day of the week with respective event start and end times. The
recording mode can be defined for each period.
2.2.1.11.2
All day
You can also enable recording for the entire selected day.
To enable, select the respective check box using “
"#
” and press “
ENTER
” or “
EDIT
”.
Symbol “
” indicates that the whole day recording option is enabled; symbol “
×
” indicates that it is not.
Check the “
All day
” option to define the recording mode.
The following recording modes can be selected:
!"
all time
!"
mot det
!"
alarm
!"
mot / alm
!"
mot & alm
!"
command
All time
In this mode, recording is continuous for 24 hours.
IMPORTANT NOTE
If “
All Time
” is selected, in the event of a blackout or if the device is switched off, the device will automatically resume recording
as soon as network voltage is resumed and the device is switched on again.
Motion
In this mode, recording starts as soon as motion is detected.
Alarm
In this mode, recording starts as soon as a sensor detects an alarm.
Motion / alarm
In this mode, recording starts as soon as either a sensor detects an alarm or a motion is detected.
Motion & alarm
In this mode, recording starts as soon as either a sensor detects an alarm and a motion is detected.
Command
In this mode, recording starts when the “
REC
” button is pressed.
Press “
REC
” to stop the recording again.
DS1093-024
38
