DS1092-020B
9
USE
The 1092/316 device may only be used as a receiver (RX).
From one to sixteen video source channels may be used employing four dedicated UTP CAT5 cables.
It may be used in combination with the following transmitters:
Ref.1092/300
→
“1ch passive transmitter/receiver”
Ref.1092/302
→
“1ch active transmitter”
INSTALLATION
PART
DESCRIPTION
1
Power LED
2
Video signal level adjustment potentiometer (brightness).
3
Video signal equalisation dip switch (definition and contrast).
4
Video signal presence LED
5
Video signal output BNC connectors
6
UTP video input RJ45 connectors
7
Power socket
Table 1
1.
Make sure that no units are powered before starting the installation procedure.
2.
Strip the UTP CAT5 cable by approximately 20 mm being careful not to cut the wires.
3.
Crimp the wire on the RJ45 connector as shown in table 3, making sure that the polarity is correct
because the UTP cable is polarised (see printing on product)
4.
Plug the male connector into the corresponding socket “6”.
UTP CABLE CONNECTION TO RJ45
PIN
COLOR
APPLICATION
POLARITY
1
White-green
Video 1
+
2
Green
Video 1
-
3
White-orange
Video 2
+
4
Orange
Video 3
-
5
White-blue
Video 3
+
6
Blue
Video 2
-
7
White-brown
Video 4
+
8
Brown
Video 4
-
4
1
2
3
5
6
7
