C AY
A S S E M B LY A N D M O U N T I N G I N S T R U C T I O N S
JG-2200
STEP 1
SHUT OFF THE MAIN ELECTRICAL SUPPLY TO THE JUNCTION
BOX FROM THE FUSE BOX/CIRCUIT BREAKER. TURNING POWER
OFF AT THE SWITCH IS NOT SUFFICIENT.
STEP 2
REMOVE MOUNTING PLATE FROM THE BACK OF THE FIXTURE
USING THE HEX WRENCH PROVIDED AND SET FIXTURE AND SET
SCREWS ASIDE.
STEP 3
LOCATE JUNCTION BOX AND PULL HOUSE SUPPLY CIRCUIT
WIRING THROUGH THE WIRE-WAY HOLE OF THE MOUNTING PLATE.
ATTACH THE MOUNTING PLATE DIRECTLY TO THE JUNCTION BOX
AND/OR DIRECTLY TO THE WALL SURFACE USING THE MOUNTING
SCREWS AND EXPANSION ANCHORS PROVIDED. IT IS IMPORTANT
TO CHECK LEVEL ON THE MOUNTED WALL PLATE.
STEP 4
USING THE WIRE NUTS PROVIDED, MAKE ELECTRICAL CONNECTIONS
BY FOLLOWING THE ELECTRICAL CONFIGURATION TABLE BELOW.
ENSURE THAT ALL ELECTRICAL CONNECTIONS ARE WRAPPED WITH
UL-LISTED ELECTRICAL TAPE.
STEP 5
ATTACH THE FIXTURE BACKPLATE TO THE MOUNTING PLATE BY
SLIDING THE FIXTURE OVER THE TOP OF THE MOUNTING PLATE
AND THEN SECURE THE FIXTURE AT THE BOTTOM WITH THE SET
SCREWS PROVIDED. BE CAREFUL TO AVOID SCRATCHING THE
FINISH ON THE FIXTURE.
STEP 6
ATTACH THE FIXTURE BODY TO THE BACKPLATE OF THE FIXTURE
BY SLIDING THE BODY OVER THE BACKPLATE AND SECURING AT
THE TOP AND BOTTOM WITH THE MACHINE SCREWS PROVIDED.
STEP 7
ONCE THE FIXTURE IS SECURED TO THE WALL SURFACE, RUN
A SMALL BEAD OF SEALANT AROUND THE PERIMETER OF THE
BACKPLATE TO PREVENT WATER FROM REACHING THE WIRE
CONNECTIONS.
STEP 8
INSTALL LIGHT BULB/S IN FIXTURE SOCKET AND RESTORE
POWER TO THE CIRCUIT. CONFIRM PROPER OPERATION OF THE
LIGHT FIXTURE.
MOUNTING INSTRUCTIONS
MOUNTING DIAGRAM
ELECTRICAL CONFIGURATION TABLE
FROM HOME
FROM LUMINAIRE
CONNECT BLACK OR RED (HOT)
HOUSE SUPPLY CIRCUIT WIRE TO:
LUMINAIRE ROUND WIRE (HOT)
CONNECT WHITE (NEUTRAL)
HOUSE SUPPLY CIRCUIT WIRE TO:
LUMINAIRE RIBBED WIRE
(NEUTRAL)
CONNECT GREEN INSULATED OR BARE COPPER (GROUND -) HOUSE
SUPPLY CIRCUIT WIRE AND LUMINAIRE BARE STRANDED WIRE
(GROUND -) TO GREEN GROUND SCREW ON CROSSBAR.
GENERAL NOTE: USE UL LISTED WIRE NUTS FOR THE
WIRING CONNECTIONS IN THIS LUMINAIRE. WRAP WIRE NUT
CONNECTIONS WITH UL LISTED ELECTRICAL TAPE.
FOR QUESTIONS, PLEASE CONTACT CLIENT SERVICES AT:
843.723.8140 OR [email protected]
