B E L M O N T W A L L
A S S E M B LY A N D M O U N T I N G I N S T R U C T I O N S
MM-3900
MOUNTING INSTRUCTIONS
MOUNTING DIAGRAM
ELECTRICAL CONFIGURATION TABLE
FROM HOME
FROM LUMINAIRE
CONNECT BLACK OR RED (HOT)
HOUSE SUPPLY CIRCUIT WIRE TO:
LUMINAIRE ROUND WIRE (HOT)
CONNECT WHITE (NEUTRAL)
HOUSE SUPPLY CIRCUIT WIRE TO:
LUMINAIRE RIBBED WIRE
(NEUTRAL)
CONNECT GREEN INSULATED OR BARE COPPER (GROUND -) HOUSE
SUPPLY CIRCUIT WIRE AND LUMINAIRE BARE STRANDED WIRE
(GROUND -) TO GREEN GROUND SCREW ON CROSSBAR.
GENERAL NOTE: USE UL LISTED WIRE NUTS FOR THE
WIRING CONNECTIONS IN THIS LUMINAIRE. WRAP WIRE NUT
CONNECTIONS WITH UL LISTED ELECTRICAL TAPE.
FOR QUESTIONS, PLEASE CONTACT CLIENT SERVICES AT:
843.723.8140 OR [email protected]
STEP 1
SHUT OFF THE MAIN ELECTRICAL SUPPLY TO THE JUNCTION
BOX FROM THE FUSE BOX/CIRCUIT BREAKER. TURNING
POWER OFF AT THE SWITCH IS NOT SUFFICIENT. NOTE: IT IS
RECOMMENDED THAT THIS FIXTURE BE INSTALLED BY AT LEAST
TWO PEOPLE.
STEP 2
CAREFULLY SLIP FIXTURE WIRING THROUGH THE BRACKET AND
FEED OUT THE BACKPLATE. SEAT FIXTURE INTO BRACKET. WITH
ASSISTANCE, POSITION ASSEMBLED FIXTURE AND BRACKET AT
OR NEAR THE JUNCTION BOX.
STEP 3
USING THE WIRE NUTS PROVIDED, MAKE ELECTRICAL
CONNECTIONS BY FOLLOWING THE ELECTRICAL
CONFIGURATION TABLE BELOW. ENSURE THAT ALL
ELECTRICAL CONNECTIONS ARE WRAPPED WITH UL-LISTED
ELECTRICAL TAPE. IMPORTANT: NEVER ALLOW FIXTURE TO
“HANG” FROM ELECTRICAL CONNECTIONS OR TO OTHERWISE
PUT PRESSURE ON THE CONNECTIONS. DURING INSTALL, THE
WEIGHT OF THE FIXTURE SHOULD ALWAYS BE PROPERLY
SUPPORTED.
STEP 4
USING MOUNTING SCREWS AND EXPANSION ANCHORS
PROVIDED, ATTACH THE BRACKET TO THE WALL AT THE DESIRED
LOCATION, ENSURING THAT THE JUNCTION BOX HAS BEEN
COMPLETELY COVERED. IT IS IMPORTANT TO CHECK LEVEL ON
THE MOUNTED BRACKET.
STEP 5
INSTALL LIGHT BULB IN FIXTURE SOCKET AND RESTORE POWER
TO THE CIRCUIT.
STEP 6
CONFIRM PROPER OPERATION OF THE LIGHT FIXTURE.
