Upright AB46 C, Service & Parts Manual

Page: 22 / 148

Section
3-4 AB46 Work Platform
Maintenance
3.3 Battery Maintenance
Hazard of explosive gas mixture. Keep
sparks, flame, and smoking material away
from battery.
Always wear safety glasses when working
with batteries.
Battery fluid is highly corrosive. Thoroughly
rinse away any spilled fluid with clean
water.
BATTERY INSPECTION AND
CLEANING
Check battery fluid level daily, especially if work plat-
form is being used in a warm, dry climate. If required,
add distilled water ONLY. Use of tap water will shorten
battery life.
The battery should be inspected regularly for signs of
cracks in the case, electrolyte leakage and corrosion of
the terminals. Inspect cables for worn spots or breaks in
the insulation and for broken cable terminals.
Clean the battey when it shows signs of corrosion at the
terminals or when electrolyte has overflowed during
charging. Use a baking soda solution to clean the
batteries, taking care not to get the solution inside the
cells. Rinse thoroughly with clean water. Clean battery
and cable contact surfaces to a bright metal finish
whenever a cable is removed.
Hazard of explosive gas mixture. Keep
sparks, flame, and smoking material away
from battery.
Always wear safety glasses when working
with batteries.
Battery fluid is highly corrosive. Thoroughly
rinse away any spilled fluid with clean
water.
3.3
BATTERY CHARGING
Charge the battery only in a well ventilated
area.
Do not charge the battery when the work
platform is in an area containing sparks or
flames.
Permanent damage will result if the battery
is not immediately recharged after dis-
charging.
Never leave the charger unattended for
more than two days.
Never disconnect the cables from the
battery when the charger is operating.
Keep the charger dry.
Charge battery as follows:
1. Check the fluid level. If the electrolyte level is lower
than 3/8 in. (10mm) above the plates, add clean,
distilled water only.
2. Connect the charger plug to a properly grounded
outlet of the proper voltage and frequency.
3. Use a charger which turns off automatically when
the batteries are fully charged.