Upright AB46 C, Service & Parts Manual

Page: 11 / 148

AB46 Work Platform
2-1
NEVER operate the machine
within ten (10) feet of power
lines.
THIS MACHINE IS
NOT
INSULATED.
NEVER operate the
boom or drive with
platform elevated
unless on firm level
surface.
NEVER position the
platform without first
checking for overhead
obstructions or other
hazards.
NEVER climb, stand or sit
on platform guardrails or
midrail.
Electrocution Hazard Tip Over Hazard Collision Hazard Fall Hazard
AB-46 I/C
WARNING
All personnel shall carefully read, understand and follow all safety rules, operating
instructions, and the Scaffold Industry Association’s MANUAL OF RESPONSIBILITIES
(ANSI A92.5) before operating or performing maintenance on any UpRight boom supported
aerial work platform.
ALL occupants must wear an approved fall restraint properly attached to designated platform anchorage point. Attach
only one fall restraint to each anchorage point.
NEVER exceed maximum platform load of 500 lbs. (225 kg) and two (2) occupants.
NEVER exceed 45 lbs. (200 N) of side force per occupant.
DISTRIBUTE all platform loads evenly on the platform.
NEVER operate the machine without first surveying the work area for surface hazards such as holes, drop-offs, bumps,
curbs, or debris; and avoiding them.
OPERATE machine only on surfaces capable of supporting wheel loads.
NEVER elevate the machine when wind speeds exceed 28 mph (12.5 m/sec.).
IN CASE OF EMERGENCY push emergency stop button to cut power to all machine functions.
ALWAYS close and secure gate after entering platform.
NEVER exit or enter platform while elevated.
NEVER use ladders, scaffolding, or other items to gain height; work only from the platform floor.
NEVER climb down elevating assembly while platform is elevated.
INSPECT the machine thoroughly for cracked welds, loose or missing hardware, hydraulic leaks, loose wire connections,
and damaged cables or hoses before using.
VERIFY that all labels are in place and legible before using. Refer to pages 6-66 & 6-67 for label identification.
NEVER use a machine that is damaged, not functioning properly, or has damaged or missing labels.
IF ALARM SOUNDS while boom is elevated, STOP, carefully retract boom and lower platform without rotating. Move
machine to a firm, level surface.
NEVER attach overhanging loads or use boom as a crane.
NEVER alter operating or safety systems without manufacturers written consent.
NEVER charge battery near sparks or open flame. Charging batteries emit explosive hydrogen gas.
NEVER replace any component or part with anything other than original UpRight replacement parts without the
manufacturer's written consent.
NEVER tow the machine. Transport by truck or trailer only.
AFTER USE , secure the work platform from unauthorized use by turning both keyswitches off and removing all keys.
SAFETY RULES
Section
2.1
Safety Rules and Operating Instructions
Safety Rules and Operating Instructions
Operation