UPPAbaby Knox 1120-KNX-CA, Manual

Page: 52 / 92

50
1
Route the Multi-Directional Tether through the
guide located on the back of the seat as shown. It is
recommended to route the webbing either through
the vehicle headrest posts or if an integrated headrest
exists, to the same side you routed the tether.
2
Route the webbing either through the vehicle headrest posts
or, if an integrated headrest exists, to the inboard side of the
headrest.
3
Hook the Multi-Directional Tether to an approved vehicle
Tether (UAS) location. Please refer to your vehicle owner’s
manual.
4
Pull up on the strap as shown until the webbing is taut.
5
Excess webbing MUST be rolled around the fabric sleeve and
secured with closure provided.
REAR-FACING INSTALLTION
– Rear-Facing Tether Use
1
ATTENTION: IT IS STRONGLY RECOMMENDED to utilize the Multi-Directional Tether for REAR-FACING installation
if vehicle is equipped with a Tether Anchor point and vehicle requirements are met. The tether will improve the stability
of your Child Restraint and reduce the risk of injury. See your vehicle owner’s manual for approved anchor locations.