© UPLIFT Desk
• 800-349-3839 • [email protected] • upliftdesk.com
6
Step 16
A. To use the arm’s wire management, first remove
the built-in wire covers.
B. There are two wire covers on each arm, one lo
-
cated under the Upper Arm and the other under
the Lower Arm. They are removed by gripping the
sides of the cover and sliding it forward (toward
the monitor) to unlock and remove. Be careful not
to pull down on the cover, doing so may damage
the covers.
C. Run your cables up and under each section of the
monitor arm and replace the covers the opposite
way that they were removed.
Step 17
A. If you have selected the Clamp Method, you can
now snap the Wire Cover onto the back of the Up
-
per Clamp on the Base as shown and insert your
monitor cables through the integrated clips.
B. In addition to holding the cables in place, there are
convenient holes to store the Allen Wrenches for
future adjustment needs.
C. The Wire Cover adds 0.75” to the back of the mon
-
itor arm. If your desk is close to a wall or cubicle,
or has a privacy panel attached to the back of the
desktop, there may not be enough space available
to attach the Wire Cover.