© UPLIFT Desk
• 800-349-3839 • [email protected] • upliftdesk.com
3
Arm Assembly & Monitor Mounting
Step 7 (Bolt-Through Method)
A. Lower the Base assembly to the desktop guiding
the Long Bolt through the hole in the desktop.
B. Slide the Lower Base Plate onto the Long Bolt and
secure it against the desktop with the M8 Washer
and Nut.
C. Tighten the Nut with the Flat Wrench while ensur
-
ing the Lower Base Plate straddles the hole.
D. Proceed with the Arm Assembly & Monitor Mount
-
ing, Step 8.
Step 8
A. The Base comes with a pre-installed limiting screw
in each of the posts which limit the rotation of each
arm to 180 degrees. If you want to limit the rota
-
tion of the arms to 180 degrees, leave these screws
installed and use the 4mm Allen Wrench to ensure
they are tight (be careful not to overtighten).
B. If you want the arms to rotate a full 360 degrees,
remove the screws with the 4mm Allen Wrench.
• We recommend saving these screws in case you
decide to limit the rotation of the arms in the future.
Step 9
Slide each of the Lower Arms onto the posts of the
Base until they are fully seated and tighten the set
screws at the back of each Lower Arm with the flat
-
head end of the 4mm Allen Wrench (or a small flat
head screwdriver). This will secure the Lower Arms to
the Base and keep them from becoming separated
during adjustment.