© UPLIFT Desk
• 800-349-3839 • [email protected] • upliftdesk.com
2
fig. 2
fig. 1
Step 5 (Bolt-Through Method)
Ensure the desktop has a hole between 0.4’’ and 3.1’’
in diameter to use this option.
Using a grommet hole that is already in your desktop
is acceptable, or you can drill a 0.5” diameter hole
anywhere on your desktop.
Bolt-Through Method
Step 3 (Clamp Method)
A. There are two sets of holes in the Upper Clamp to
use for different desktop thicknesses.
• There are two screws pre-installed in the top
two holes of the Upper Clamp. Leave the screws
in those holes if your desktop is between 0.4’’
and 2.1’’ thick (fig. 1)
• If your desktop is between 2’’ and 3.3’’ thick, use
the 4mm Allen Wrench to remove the screws
from the top two holes and insert them into the
bottom two holes (fig. 2)
B. Use the 4mm Allen Wrench to adjust the two
screws in the Upper Clamp so that there is about
0.25” of thread between the plate and screw
heads.
C. Position the Lower Clamp assembly in the orienta
-
tion shown and press it against the Upper Clamp
so the two screws go through the two key slot
holes in the Lower Clamp.
D. Slide the Lower Clamp assembly down so that
the screws are at the top of the key slot holes and
tighten the screws with 4mm Allen Wrench.
Step 4 (Clamp Method)
A. Using the knob screw, adjust the bolt on the bot
-
tom of the Lower Clamp so that the opening is
wide enough to accommodate the thickness of
the desktop.
B. Slide the assembly onto the back of the desktop,
then tighten the knob screw to secure the Base to
the desktop.
Step 6 (Bolt-Through Method)
A. From the top of the Upper Base Plate (the side
opposite from the countersunk holes), insert the
Long Bolt through the square hole until the square
shank of the Bolt fits into the Plate’s square hole.
B. Align the Upper Base Plate with the bottom of the base
in the orientation shown and attach it using the three
M6x12 Flathead Screws and the 4mm Allen Wrench.
0.25”
0.25”
0.25”
0.25”
0.25”
0.25”
0.25”
0.25”
0.4”
3.1”