THE GRATER, SHREDDER AND JULIENNE PLATE ASSEMBLY
To fit the plate of your choice to the hub and shaft, line up the key hole slots on the plate with the
locating pins on the hub, slip the plate over the pins and secure it by turning the plate in a clockwise
direction until it shoulders up firmly on the pins. This can be most safely accomplished by placing the
plate face down on a butcher’s block and turning the hub into position from above.
PLATE INSTALLATION
FIGURE 7
Turn plate clockwise
to lock
Keyhole Slot
Pin
Hub
Make sure that the thrust bearing is properly positioned on the shaft. Make sure the set screw on the
thrust bearing is tightened securely. A loose thrust bearing will allow clatter and damage the VS9.
NOTE:
Do not remove the thrust bearing for cleaning.
Page 10
