Page 14 of 27
11 -Install the new Index Spring.
12 -The leg of the spring which extends out-
ward from the coil diameter must be aligned
and seated in the recessed slot in the end
of the Print Drum.
13 -Place the small end of the white plastic
bushing in the hole where the spring was
just installed.
14 -Press the bushing into the hole.
Insert your index finger through the large hole in the
print drum and use it to guide the spring as it is in-
serted through the small hole. The end of the spring
without the extended leg goes in first and should be
guided through the center of the large bushing on the
opposite end of the Print Drum.
If you have one available, using an arbor press is the
ideal way to install this bushing. If you use a ham-
mer be very careful not to damage the thin flange of
the bushing during installation.
The shoulder of this bushing is slightly larger than
the hole and must be pressed into the bottom of the
flange.
Figure 31
Figure 32
Figure 33
Figure 34
Figure 35
MAINTENANCE
10 -Remove the small white bushing from the
opposite end of the Print Drum.
The bushing will exit through the bottom of the
Print Drum as shown.
