Page 11 of 26
MAINTENANCE
5 - Remove one of the Rubber Friction Bearer
Rings.
It does not matter which one is removed.
6 - Remove the old Print Drum Cover by grip-
ping one edge with your fingertips and roll-
ing the cover towards the end of the Print
Drum where the friction bearer was re-
moved.
7 -To install the new Drum Cover, stretch one
end of the cover over the end of the Print
Drum without the friction bearer.
8 - Pull the cover down in small steps, rotating
the drum and pulling in different areas as
you progress.
9 - Replace the Rubber Friction Bearer Ring
and reassemble the coder in the reverse
order of the disassembly process.
Moistening the inside of the Drum Cover with a so-
lution of water and a few drops of liquid dish deter-
gent will make this process easier.
These rings are tight and installation does take a bit
of effort. Do not use pliers to grip the rubber ring or
it will tear.
Be sure the print drum brass washers are reinstalled
on either side of the print drum.
FIGURE 17
FIGURE 18
FIGURE 19
FIGURE 20
FIGURE 21
