17
Please contact Universal
®
Gym Equipment/FFA Corp. for missing or defective parts at one of the following:
Phone 1-800-
472-9856 or Fax 1-662-495-5038 or E-mail at [email protected].
Mailing
address: Universal
®
Gym Equipment/FFA Corp. - 100 Tubb Ave. West Point, MS 39773.
Website www.universalgymequipment.com
FIGURE 6
38
28
28
84
75
84
75
6
5
17
ADJUSTMENT
BOLT
39
21
21
40
34
33
25
26
23
FIGURE 6
Step 57.
Step 58.
Step 59.
Step 60.
Step 61.
Step 62.
Push BINDING OF WEIGHT SHROUD (38) completely onto
edges of WEIGHT SHROUDS (28).
Attach WEIGHT SHROUDS (28) to WEIGHT TOP FRAME (5) and WEIGHT BASE (6)
with 5/16” x 1/2” HEX HEAD BOLTS (75) and 5/16” WASHERS (84).
NOTE:
The following accessorys can be used at different locations on the unit.
The locations shown are the most common. See your exercise chart for further information.
Attach the LAT BAR (21) to the hook on the TOP CABLE (39).
Attach the AB STRAP (24) to the hook on the upper end of the AB CABLE (40).
Attach either the ANKLE STRAP (26), HAND STRAP (25) or CURL BAR (23) to the hook at the lower end of the AB
CABLE (40) with SNAP HOOK (33) and LINK CHAIN (34).
Over time the cables will need to be adjusted to remove excess slack. This can be done by first adjusting location of
PULLEY (50) in FLOATING PULLEY BLOCK (17). Then if only a slight amount of adjustment is needed thread the
cable adjustment bolt into the SELECTION ROD (22) until the slack has been removed and then tighten locking nut
against SELECTION ROD.
