![background image](http://html1.mh-extra.com/html/universal-remote-control/complete-control-msc-400/complete-control-msc-400_manual_1058636005.webp)
Notice to User
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or tele-
vision reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one more of
the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Warning
Changes or modifications not expressly approved by the manufacturer could void
the user's authority to operate the equipment.
Note : The manufacturer is not responsible for any Radio or TV interference
caused by unauthorized modifications to this equipment. Such modifications
could void the user's authority to operate the equipment.
M S C - 4 0 0 S y s t e m Q u i c k R e f e r e n c e G u i d e
M S C - 4 0 0 S y s t e m Q u i c k R e f e r e n c e G u i d e
F r o n t V i e w s - F l i p f o r R e a r V i e w s
F r o n t V i e w s - F l i p f o r R e a r V i e w s
Start with the antenna angle set to 45
degrees and positioned so that the
long side of the antenna is facing the
customer’s favorite seating position.
Power LED indicates
that the MSC-400 is
powered on.
USB 1 LED indicates that
the USB Programming Port
(Front Panel USB) is
connected to a PC.
Learning Sensor for learn-
ing IR commands.
Normally, learning is more
convenient via a remote.
Front Panel USB port is
used ONLY for
PROGRAMMING
USB 2 LED indicates that
the USB PC Keyboard Port
(Rear Panel USB) is
connected to a PC.
Sensor LEDs light when a
Sensor is sensing that a
component is ON (Video is
present or Voltage is high).
MSC-400
Master System Controller
Front Panel
RFX-250
Narrow Band RF Receiver
Front Panel
NOTE: MSC Editor Software is not
included with the MSC-400. It can
only be downloaded from the URC
Dealer Only website. If you have
not registered yet, call your distrib-
utor or sales representative for a
registration code and use the
Dealer Login at:
www.universalremote.com
Status LED lights whenever an RF
signal is received and UNDER-
STOOD. The LED will continue to
light with each step of a macro.
Once the RFX-250 is correctly con-
nected, the POWER LED lights.
If the RF LED lights without a
button push on the remote, the
RFX-250 must be moved to a
new mounting location. It is
receiving in-band RF INTERFER-
ENCE.
When a button is pushed, the
RF LED indicates a signal is
detected.
45°