PAG
.
3
English
rev 1.1
QUICK INSTALLATION GUIDE
Example 1 –
Basic System
Example 2 –
DISEqC switches
Example 3 –
Combined with terrestrial
Example 4 –
Motorized system
QUICK INSTALLATION GUIDE
Follow next steps for the correct installation of this receiver.
STEP 1: CONNECTIONS
The coaxial cable, with satellite signal, must be connected to the “IF IN” connector. The “TV SCART”
connector must be connector to the TV set.
The receiver also includes an UHF modulator, allowing connecting a TV set or VCR. However the
picture quality will be a little poorer. The modulator has an antenna input and the output range is
from channel 21 to 69. This will allow you to mix the existing antenna signals with the output channel
generated by the receiver.
The modulator output is factory preset to channel 38. You can change the output channel in the TV
system menu that you can find in System Setup menu.
You will also have to tune your TV set accordingly, in order to receive the picture from the receiver.
Depending on the type of installation, the receiver should be connected and configured following next
examples.
STEP 2: BASIC CONFIGURATION OF THE
RECEIVER
The receiver includes an installation assistant (Quick Setup)
that will help you to setup the different parameters.
When the receiver is turned on at first time (using the button at
the rear panel of the receiver), the next menu is shown on the
TV (Image 1):
The receiver is programmed with all the channels of Astra
(at position 1 of the DISEqC), Hotbird (at position 2 of the
DISEqC), Hispasat (at position 3 of the DISEqC) and Turksat
(at position 4 of the DISEqC). If your installation is different to
IMAGE 1
Summary of Contents for U4111
Page 1: ...U4111 ...
