4 / 5
P/N 1073514A
• REV 01.01 • ISS 11SEP18
Keypad programming flowchart
Default values marked with
*
Entering Menu is always done with B(3 s) + 000000 if the Master Code is not changed.
Submenu 1
- Change Master Code. The Master Code must be 6 digits. After enrolling new
Master Code the ACL875W automatically exits the Menu and the new master code must be typed
to enter the menu.
Submenu 2
- Select Type of Wiegand. The Wiegand selected must be the same as the
controller’s Wiegand Input where the ACL805SUW-RDMF Keypad is being connected. Example:
If you use a controller that recognizes Wiegand 34 bit, then enter the menu of ACL805SUW-
RDMF, press 2, then press 3.
Submenu 3
- Select Output Protocol. Keypad have the following outputs:
3-1
Single Wiegand - Keypad will send code in wiegand format
3-3
Clock & Data - Keypad will send the code in Clock & Data format
3-5
8 bit per key - Each key press will be sent as 8 bit data immediately. Key press will be sent as following table:
3-6
6 bit
per key -
Each key press will be sent as 6 bit data immediately.
3-7
4 bit per key - Each key press will be sent as 4 bit data immediately.
Submenu 4
- PIN C
ode Length. If “0” is selected, then any PIN Code with any length can be sent,
but the PIN Code is typed with “A” for confirmation (ex. 123 + A). If 1 to 8 is selected the PIN Code
length is set by the number selected.
Key
0
1
2
3
4
5
6
7
8
9
A
B
Wiegand output
240
225
210
195
180
165
150
135
120
105
90
75
*
*
*
