United Technologies Carrier Transicold 69UG15, Operation And Service

Page: 31 / 76

3–1 T-360
SECTION 3
OPERATION
3.1 GENERATOR SET INSTALLATION
The generator set is mounted under the center of the trailer chassis and is easily handled with a fork lift truck capa-
ble of handling 2,000 pounds. The fork lift pockets provided are accessible from either side. Mounting clamps are
designed to be attached to outside I-beam flanges only. Maximum chassis width is 38 inches on center.
1. Standard Mount
a. Loosen mounting bolts (see Figure 3.1 ) sufficient to push mounting plates to the outermost position.
b. Place forks into fork lift pockets of generator set. Attach safety chain between unit and fork truck.
c. Center generator under chassis slide mounting plates fully onto chassis I-beams and torque mounting
bolts to 80 - 90 ft-lbs (11.1 - 12.4 m-kg). Upon completion, remove safety chain before removing forks of
fork lift truck from unit.
2. Quick Mount
a. Loosen mounting bolts (see Figure 3.2 ) sufficient to bring clamp to open position. To orient in open posi-
tion, lift nut end of bolt out of slot. Clamp will fall open.
b. Place forks into fork lift pockets of generator. Attach safety chain between unit and fork truck.
c. Center the generator set in desired position under chassis.
d. Lift clamp in place, ensuring bolt is secured in slot.
e. Tighten bolt to 55 - 65 ft-lbs (7.6 - 9.0 m-kg).
f. Upon completion, remove safety chain before removing forks of fork lift truck from unit.
Figure 3.1 Generator Set Mounting - Standard Mount
$
$ $
ROADSIDE VIEW
Tee Nut
Washer, Spherical, Male
Washer, Spherical, Female
Bolt
Washer, Belleville
Roll Pin
Mounting Plate
Generator Frame
FORK LIFT POCKET
CONTAINER FLOOR CROSS I-BEAM
REAR OF CHASSIS
VIEW A-A