United Technologies Carrier Transicold 69UG15, Operation And Service

Page: 57 / 76

5–11 T-360
NOTICE
Although the drive gear and mating surface of the generator will generally keep the generator
coupled to the engine, even with all of the bolts removed, it is safest to start installation of the
top generator bolts first, just in case the generator shifts.
30. With all of the generator mounting bolts secured, use the lift to raise the generator/engine in order to remove
the support blocks under the engine.
31. Place the two generator support plate mounting bolts down into the generator support plate in order to line
up the mounting bolt holes with the shock mounts.
32. Ensure that the large washers placed on the Shock Mounts and slowly lower the generator/engine so that
the generator support plate holes line up with the shock mount holes.
33. Remove the generator support plate bolts (used for alignment), and install the bolts and large washers from the
bottom of the shock mounts through the generator support plate. Secure the bolts (2) with nuts, torque to 75 ft-lbs.
34. Tighten the engine shock mount bolts, torque to 90 ft-lbs.
35. Replace the lower radiator access panel and secure with bolts/washers (3).
36. Re-secure the battery charger cables to the battery charger. Refer to Figure 5.10 , Figure 5.11 .
CAUTION
!
Observe proper polarity when installing the battery or connecting a battery charger, the nega-
tive battery terminal must be grounded. Reverse polarity may damage the charging system.
When charging the battery in unit, isolate the battery by disconnecting the negative battery ter-
minal first, then the positive. Once the battery has been charged, connect the positive battery
terminal first, then the negative.
Figure 5.10 Battery Charger (PIDs Prior to UG2019)
Figure 5.11 Battery Charger (PIDs UG2019 and Up)
Ground
Output -
Power Cable
AC Wiring from Generator
DC Wiring to 12v Battery
Red (+)
Black (-)