19
-85%/88AEA9%
-
Q&@
=@ ?@ ,@ '@ X
&= X ?,' - =(
locate indicated parts.
0
Y
kk"9.-h9&'9 ./().-D(-2''&-(&-.-..(2&. .-)(D"(./(9._kk
).-D()/9.)-3./(^;' /.')/()
&#"
&#
& #Y
for hose are blocked.
Unhook air hose from the air switch and blow through
A Y A
Y
clear the blockage.
2. The air inlet, burnpot, interior combustion air
chambers, combustion blower, or exhaust
pipe are blocked with ash or foreign material.
0 -
? K
Make sure the door is closed and that the gasket is in
good shape. If the ash door has a latch, make sure the
ash door is properly latched and the gasket is sealing
A !
to fall through under the burnpot, make sure the slider
KY
4. Vent pipe is incorrectly installed.
Check to make sure vent pipe installation meets criteria
' Y
Check the connectors that attach the gray wires to the
air switch.
6. The gray wires are pulled loose at the Molex
connector on the wiring harness.
Check to see if the gray wires are loose at the
Molex connector.
F 6
With the stove on, check to see if the combustion blower
is running. If it is not, you will need to check for power
going to the combustion blower. It should be a full cur-
rent. If there is power, the blower is bad. If there is not,
see #8.
8. Control board not sending power to combus-
tion blower.
If there is no current going to the combustion blower,
check all wire connections. If all wires are properly con-
nected, you have a bad control board.
9. Control board not sending power to air
switch.
There should be a 5-volt current (approximately) going
to the air switch after the stove has been on for 30 sec-
onds.
10. Air switch has failed (very rare).
To test air switch, you will need to disconnect the air
hose from the body of the stove. With the other end still
attached to the air switch, very gently suck on the loose
end of the hose (you may want to remove the hose en-
it is clear). If you hear a click, the air switch is working.
% 6#-%05 88 $6/ `#6$ 6#E 9#$#%
/%#A-A6/
All manuals and user guides at all-guides.com
all-guides.com
