8
INSTALLATION
"D(."''1./("/2(1)1).(27
$:H8
-.(
0 5+`
-&.-
To achieve a center vertical installation a 45º el-
bow and a clean-out tee can be used to offset the pipe from
the exhaust outlet to the rear center of the stove.
-&.-
Install L-Vent elbow in place of clean-out tee. Lo-
cate stove. Drop plumb bob to center of tee outlet, mark
point on ceiling. Install ceiling support and L-Vent pipe per
5+`
1. Always maintain 3” clearance from combustible materi-
Y
= # Z
hole in roof, always 3” larger all the way around pipe.
A Y
materials, nail to the roof along upper edge. Do not nail
lower edge. Seal nail heads with non-hardening water-
proof mastic.
3. Apply non-hardening, waterproof mastic where the storm
Y
Y
Mobile home installations must use a spark arrester.
3D(."''1.-(F). "/2(1)1).(2
Adapters are available to adapt from 3” L-Vent to 6” or 8”
6+# >0&&@
As an alternative, 3” or 4” L-Vent can be run inside existing
>0&&@
This is the preferred method.
0 Z
FIGURE 10
FIGURE 11a
FIGURE 11b
12” MINIMUM CLEARANCE
TO ROOF
VERTICAL ROOF VENT
ATTIC
INSULATION
SHIELD
3” MINUMUM
CLEARANCES TO
COMBUSTIBLES
3” MINUMUM
CLEARANCES TO
COMBUSTIBLES
PELLET VENT TO
CHIMNEY ADAPTER
(SPV-CA)
UNIVERSAL
CONNECTOR
PELLET
VENT
NOTE:
THIS METHOD
IS PREFERRED
EXISTING
CHIMNEY
SYSTEM
EXISTING
CHIMNEY
SYSTEM
TO
APPLIANCE
CLEANOUT
TEE
45 DEGREE ELBOW
All manuals and user guides at all-guides.com
