W A S H S E L E C T I I
Document Number:
WS21002
51
Document Title:
WSII Operations Manual
allows the wash to send a signal to the coin box if it is malfunctioning or not in service,
causing the coin box to go out-of-service. Once the coin box has gone out of service, it will
display the standard Out of Service message.
If the Wash Select II goes Out of Service while it contains credit in escrow, a voucher will be
printed for the customer.
To enable this feature, follow the steps below.
1.
Using the toggle switch at the top of the CPU board, place the Wash Select II in
setup mode by moving the switch toward the back of the Wash Select II case.
(The CPU board is located on the inside right wall of the Wash Select II case.)
2.
Using the (3) key to scroll forward and the (1) key to scroll back, scroll through the
main menu until the “Wash Interface” option is displayed. Press the (*) key to
enter.
3.
Scroll through this menu until the “Wash Fault” option is displayed, and then press
the (*) key to enter.
4.
Press the (1) button for “YES” or the (3) button for “NO”.
5.
The following prompt comes up. You must select whether the Wash Select II
should fault when a high (on) signal is detected or a low (off) signal. "On" is the
default.
6.
1=FAULT WHEN ON
7.
3=FAULT WHEN OFF
8.
Next you are prompted to enter how long (in seconds) the Wash Select II should
delay after it sees the signal before it goes out of service. It can be anywhere from
1 to 300 seconds, inclusive. The default is 10 seconds.
2.8.7
OOS Timer
If your car wash is using “Cycle Complete” handshaking, a feature of the Wash Select II is
that it can go out of service if the wash-in-
use signal remains off for too long. “Too long” is
defined by the OOS timer, which has a default of 60 seconds. Your wash may require a
different amount of time. If so, follow the steps below to configure.
Note:
This feature may require hardware changes. If after it has been enabled, you find it
does not work, refer to the Wash Select II Installations Manual for wiring instructions.
1.
Using the toggle switch at the top of the CPU board, place the Wash Select II in
setup mode by moving the switch toward the back of the Wash Select II case.
(The CPU board is located on the inside right wall of the Wash Select II case.)
2.
Using the (3) key to scroll forward and the (1) key to scroll back, scroll through the
main menu until the “OOS Timer” option is displayed. Press the (*) key to enter.
3.
Scroll throu
gh this menu until the “OOS Delay” option is displayed, and then
press the (*) key to enter.
