H y d r a u l i c
R o t a r y H a m m e r D r i l l
2 2 4 2 6 0 0 1 0
Translation of the original manual,
compiled: 24.02.17
224260010_BA_en_Version_CSU_00
Page 16 of 18
Storage
Unused machines and machine tools should be kept in a dry, closed room.
Keep them free from damaging influences such as damp, frost or large temperature fluctuations as well as
mechanical damage. Always store the machine in a way that important machine instructions, e. g. on
stickers and signs, are legible.
NOTICE – Always connect the loose ends of the hoses with each other, if possible.
Disposal
Dispose of machine and worn out/defective machine tools according the local/national regulations. Fully
disassemble the machine for the necessary disposal. Separate materials according to local environmental
specifications. Dispose environmentally hazardous greasing, cooling or cleaning agents in order to avoid
environmental contamination.
Environmental Regulations
When working on or with the equipment, it is imperative to observe all legal requirements in regards to
waste-disposal and proper recycling. In particular during installation, repair and maintenance work, water
damaging agents, such as
lubricating grease and oil,
hydraulic fluid,
coolant,
solvent containing cleaning agents
must not leak into the ground or reach the sewage system.
These materials must be stored, transported, contained and disposed of in suitable containers!
Troubleshooting
The following table shows possible problems and their causes:
Problem
Cause
Remedy
a
Machine does not
start
Not connected to hydraulic supply
Defective hydraulic hoses or quick
couplings
Connect and open the hydraulic line
Replace hydraulic hoses or quick
couplings
b
Machine keeps on
running after
releasing the safety
lever control
Hydraulic hoses inverted
Connect hydraulic hoses correctly
c
Low speed
Too little operating pressure
Too small hose diameter
Too little volume flow
Too high back pressure
Increase operating pressure
Choose larger hose diameter
Increase volume flow
Reduce back pressure
d
Speed too high
Too high operating pressure
Too high volume flow
Adjust to max. operating pressure
(see technical specification)
Reduce volume flow
e
Hydraulic fluid
leaking
Wrong hydraulic fluid
Damaged sealings
Use appropriate hydraulic fluid
Ensure sufficient cooling
Replace sealings
g Other problems
Contact authorized expert company
We ask you to send the machine to the supplier, if necessary.
