H y d r a u l i c
R o t a r y H a m m e r D r i l l
2 2 4 2 6 0 0 1 0
Translation of the original manual,
compiled: 24.02.17
224260010_BA_en_Version_CSU_00
Page 10 of 18
Safety Instructions for Prevention of Workplace Hazards
WARNING – The following applies unless otherwise stated in the machine’s operating
instructions booklet: The machine is not insulated to protect against an electrical power surge.
CAUTION – risk of injury!
Hands may be crushed, seized or otherwise injured.
Keep your hands away from areas which are marked with this symbol.
CAUTION – risk of injury!
Remove all sources of danger which could lead to slipping, tripping or falling (e.g. slippery
surface, hoses, cables).
Keep the work area clean and tidy.
PROHIBITION – Eating, drinking and smoking are forbidden during operation.
WARNING – Explosion hazard!
Operate the machine only according to the intended use.
The machine is designed for the use in areas exposed to explosion hazards as well.
The generation of heat and –eventually- sparks at the drilling point is characteristic for drilling
certain material. Therefore the drilling point has to be cooled continuously.
Consider the following:
Valid local explosion protection directives.
Technical specification of the machine.
Markings on the machine.
Avoid the generation of sparks.
When operating the machine, do not push or beat against other material
and hold the machine firmly and safely by hand.
Do not slide the machine over the ground.
If heat generation exceeds the specified surface temperature, the machine has to be
stopped instantly. It may be re-started only after having eliminated the cause for the fault.
The work area and the other close working areas should always be protected from sparks.
Flammable and explosible material has to be removed from the work area before starting
work. Among others, this relates to dust deposits, cardboard, packing material, textile, wood
and wooden splints, but also flammable fluids and gas.
Ensure adequate lighting.
Be extra careful in unfamiliar surroundings. There is a risk of hidden hazards such as electric lines or other
supply lines. Make sure when operating the machine that no electrical cables, gas pipes or similar could be
damaged. Use suitable and personal protective equipment.
CS Unitec, Inc.
• Toll-free: 800-700-5919 • Ph: 1-203-853-9522 • Email: [email protected] •
www.csunitec.com
