Unisys E-@CTION EFP9800, Owner'S Manual

Page: 34 / 268

Operating the Printer
2–12 3255 4073–002
Validating Slips and Checks
The EFP9800 can print on slips and forms up to five-parts thick (the receipt is
included as one or two of the parts depending if it is one-ply or two-ply). For
more information on the types of slips and forms you can use, see “Ordering
Paper and Supplies” in section 1.
Follow this procedure to validate slips and checks.
Note: Do not use this procedure for check verification. See “Verifying
Checks” earlier in this section.
Be sure to insert the slip or check properly to ensure printing in the correct
locations. Insert standard size slips and checks from the top, using the slip stop
to position them correctly.
1. Insert the slip/check from the top, with the side to be printed facing you as
shown in the illustration.
2. Slide the slip/check into the printer until it meets the slip stop and to the
right until it lines up against the wall.
The Slip In LED flashes green. When the slip/check is inserted properly, the
Slip In LED is lit steadily.
3. Depending on your printer setup, the printer may automatically begin
printing, or you may have to perform the action programmed for your
printer, such as pressing a particular keyboard key. Follow the instructions
from the host computer.