24
INSTALLING THE DISHWASHER Cont'd
1
Turn on the power supply (or plug the power cord into the outlet, if equipped).
2
Turn on your dishwasher (refer to the
User Guide
for instructions).
3
Open the door, select the Rinse only cycle, and press
START/Cancel
, close the door within
four seconds of pressing
START/Cancel
.
4
Make sure that water enters the dishwasher. If water does not enter the dishwasher, check
to be sure that water and power are turned on.
5
Check for leaks under the dishwasher. If a leak is found, turn the power supply off, then
tighten connections. Restore power after the leak is corrected.
6
Check for leaks around the door. A leak around the door could be caused by door rubbing
or hitting against adjacent cabinetry. Reposition the dishwasher if necessary.
See “Step 9: Position the dishwasher under the countertop”
7
When the dishwasher is draining, check the drain lines. If leaks are found, turn power off at
the breaker and correct plumbing as necessary.
8
Restore the power after corrections are made.
See “Step 12: Connecting the water supply line”
9
Open the dishwasher door and make sure that most of the water has drained. If not, check
that the disposer plug has been removed and/or the air gap is not plugged.
See “Step 13: Connecting the drain hose”
. Also check the drain line for kinking.
10
Run the dishwasher through another fill and drain cycle. Check for leaks and correct if
required.
• Place the toekick against the legs of the dishwasher. The slots should align with the toekick
bracket screw holes. Allow the toekick to touch the floor. Install the toekick screws.
Step 15: Wet testing the dishwasher
Step 16: Replacing the toekick
Note:
Make sure that you install the toekick in the correct direction. The toekick should be aligned correctly
with the junction box.
You'll need:
Phillips screwdriver
Summary of Contents for CLASSIC RETRO UGP-24CR DW T
Page 27: ......
