21
INSTALLING THE DISHWASHER Cont'd
1
Cut on the marked line as required for your
installation. The drain hose’s molded end will fit
5/8” or 1" diameter connections on the air gap,
waste tee, or garbage disposal.
2
If a longer drain hose is required, you can add
up to 42" (1.1 m) of length, for a total of 10 ft.
(3.01 m) to the factory installed hose. Use 5/8”
or 7/8” inside diameter hose and a coupler to
connect the two hose ends. Secure the
connection with screw-type hose clamps.
Step 13: Connecting the drain hose
IMPORTANT:
Follow all local codes and ordinances.
Cutting lines
IMPORTANT:
Do not cut
corrugated portion of hose
3
Secure the drain hose to the air gap, waste tee, or garbage disposal with a screw-type
clamp, using the appropriate method below.
See “Drain preparation” on page 6
, if you do not
know which method to to use.
IMPORTANT:
For proper drain operation, the total drain hose length must not exceed 10 ft. (3.01 m).
Screw-type hose clamp
Coupler
Scew-type hose clamp
Summary of Contents for CLASSIC RETRO UGP-24CR DW T
Page 27: ......
