background image

U G P - 3 0 E   –   C T 2  

 

13

Installing the Rangetop 

 

x

 

Remove the rangetop from its package and set aside all burners, burner caps 
and grates. 

x

 

Gently slide in the cooktop into the cut-out, make sure your cut-outs are 

there for the gas connection and electrical hookup (if you choose to use it). 

x

 

Once this is done you’re now ready to slide the rangetop all the way back to 
the wall. 

x

 

Install all burners and burner caps 

x

 

Install all grates. 

 

Connecting gas to rangetop 
 

This rangetop is designed to operate at a pressure of 4” of water column on natural 
gas or 10” of water column on propane gas (LPG). 
 
Make sure you are supplying your rangetop with the type of gas for which it is 
designed. 

It’s shipped for use with NG.

 This rangetop is convertible for use on 

natural gas (LPG) also. When using this rangetop on LPG gas, conversion must be 
made by a qualified LPG installer before attempting to operate the rangetop on that 
gas. 
 
For correct operation, the pressure of natural gas supplied to the regulator should be 
between 4” and 5” of water column. For LP gas, the pressure supplied must be 
between 10” and 12” of water column. 
 
When checking for correct operation of the regulator, the inlet pressure must be at 
least 1” more than the operating manifold pressure as given above.  
 
The pressure regulator located at the inlet of the rangetop manifold must remain in 
the supply line regardless of whether Natural (NG) or Propane (LP) gas is being 

used. 
 
A flexible metal appliance connector used to connect the rangetop to the gas supply 
should be 3 feet/91.4 cm max. in length for easy installation. In Canada, flexible 
connectors should be single wall metal connectors less than 6 feet/182.9 cm in 
length. 
 
Shut off the main gas supply valve before removing the old cooking appliance (if 
applicable) and leave it off until the new hook-up has been completed. Don’t forget 
to relight the pilots on other gas appliances when you turn the gas back on. 
 

Because hard piping restricts movement of the rangetop, the use of a CSA certified 
flexible metal appliance connector is recommended unless local codes require a hard-

Summary of Contents for UGP-30E CT2










Reviews: