14
Gray splitter for temperature and black for
receiver and speed.
Two splitters mounted to increase number
of sensors.
Two different cable splitters are used. A gray
version is used for temperature and a black
version for everything else.
The splitters reduce the number of cables to
the steering wheel.
The splitters reduces the number of cables to
the steering wheel and is part of the perma-
nently installation. Make sure that splitters are
securely fasten to the frame.
MAGNET RECEIVER
The magnet receiver uses permanently
magnets placed in the asphalt to trigger the
Laptimer. There is typically between 1 and 3
magnets on a track. If there are more than
one, the rest is used for split points.
Magnet receiver mounted at the lowest
point on the go-kart.
The magnet receiver need to be mounted as
close to the asphalt as possible, typically on
the bottom plate at the front. Use the included
bracket and drill a hole in the plate. The receiv-
er need to be facing either against the front or
the rear. Do not mount it facing left or right.
IR RECEIVER
The IR receiver use infrared light to trigger the
Laptimer. A Unipro IR transmitter is placed at
the start/finish line and the infrared light goes
across the track. The infrared receiver placed
on the kart will receive the infrared beam and
trigger the Laptimer.
IR receiver mounter at the front, facing the
right way at the start/finish line!
I n s t a l l i n g t h e
L a p t i m e r
Installation
Summary of Contents for UniGo One
