Unipro UniGo One, User Manual

Page: 32 / 60

32
Setup mode
C o n f i g u r i n g
t h e L a p t i m e r
DRIVER SETUP
The driver menu contains all the settings
related to the driver.
All settings related to the driver are on the
driver menu screen.
Use the
up
( ) and
down
( ) buttons to
move around in the menu and press the ok
button ( ) on the relevant line to change the
value. To accept the changes press the
ok
button ( ) again or press back ( ) to cancel
the changes and revert to the original value.
NAME
To ease the identification of the files it is a very
good idea to enter the driver’s name. Please
enter the name as a normal text like described
next.
NATIONALITY
To ease the identification of the files it is a very
good idea to enter the driver’s name. Please
enter the name as a normal text like described
next.
SENSORS SETUP
The track menu contains all the settings related
to the track.
FLEX INPUT
It is possible to connect a sensor directly to
the Flex connector. There is not limitation
when a single sensor is connected directly and
there is a wide selection of analog, digital and
”intelligent” sensors. If more than one sensor
is to be connected, please select ”Splitter”. The
splitter is an optional accessory that makes it
possible to connect two different sensors to the
Flex connector.
SPLITTER #
If the Flex input is set to ”Splitter” you will see
”Splitter #1” and ”Splitter #2” lines. Here it
is possible to select different sensors to each
input, but not all combinations are possible.
It is not possible to connect two intelligent
sensors like Lambda and IR Box at the same
time. The intelligent sensor need to be con-
nected to Splitter #2 and then a simple sensor
to Splitter #1.
FLEX INPUT VALUE
The track menu contains all the settings related
to the track.
SPLITTER # VALUE
The track menu contains all the settings related
to the track.