Unipro UniGo One, User Manual, Page: 45 / 60

45
Operating UniGo
R e f e r e n c e
G u i d e
Run mode 3 will show two channel values
and best and max values.
Above the lap time, the lap number and the
recording icon, the best lap time and the best
lap number are shown permanently.
Two big data channel values are shown on the
display. The two channels are configured un-
der ”SET UP SCREENS” on page 30. A small
text next to the value will help you identify the
channel.
The bottom line will show the last lap maxi-
mum value for the two channels. This is updat-
ed every time the start/finish line is passed.
ANALYZE MODE
The analyze menu contains everything
needed to analyze the data directly on UniGo.
Analyzing data will always be faster and better
using a computer though!
The general analyze icon shown above will
bring you to the last analyze screen you were
on. That could be time analysis, min/max or
counters.
It is also possible to rum directly to the analyze
screen you wish from the rolling menu.
SESSION SELECT
UniGo logs data into sessions. Each
session contains all the information about the
race and each time the engine is started, a
new session is made.
List of sessions. Select the one you want.
Use the
up
( ) and
down
( ) buttons to
move around in the list and press ok button
( ) to either select the session or delete it.
The scrollbar to the right shows where you are
in the total list of files.
The header shows information on the best lap
time, the sessions’ data and time, the track
name and finally the drivers name.
TIME ANALYSIS
Several screens can be used to analyze
the timing of the race. These screen are listed
in the following section. To change between
the different screen, simply press the
mode
button ( ) until you get to the screen you
want. Press the
back button ( ) to go back to
the analyze menu again.
Different people have different preferences.
Therefore the time analysis screen is remem-
bered so it will start on the same screen each
time.
OVERVIEW
When starting analyzing a new session, the
overview screen is a good place to start. This
screen will show the three best laps including
the minimum and maximum of three data
channels. It also provides information about
the theoretical best lap time, number of laps
and the average RPM for the whole session
and the starting time and date.