Receiver type
This is the receiver type screen.
The Unipro Laptimer can use all types of receivers. You can
choose between IR (infrared), Loop (AMB active loop) and
Stripe (magnets).
Use the
and
buttons to choose the receiver type
connected to the Laptimer. If you use a loop or infrared receiver, you can skip the
explanation about stripe setup!
Stripe setup
This is the stripe setup screen.
If the receiver type is set to Stripe (magnets) this is the next
step. It is the most important setup before you start driving
on a new track. You need to set two values. The number of
magnets from the pit to the finish line (2 in this example)
and the total number of magnets on the track (3 in this example).
Press
to set the two values (see the next two screens and the example with a typical
track).
Magnet count
Set the total number of magnets on the track.
When you press
from the stripe setup screen, you can
edit the total number of magnets on the track. You can
choose between 1 and 8 magnets. If you don’t know the
number of magnets, you can set the Laptimer to use only
one magnet and then drive one lap. Then you can see how many times the Laptimer triggers.
Use the
and
buttons to adjust the total number of magnets.
When the correct number of magnets are entered, press
to edit the number of magnets
from the pit to the finish line (See the next screen).
UNIPRO – The original Laptimer
13
