SAGEON PSMC I PRODUCT MANUAL
PM990-2999-00, Rev 5
3-18
and then raise above to trigger an Auto Eq. cycle. Its default is the Low Voltage Alarm
Threshold. You can also set the Auto Eq. OFF threshold; which is the voltage level that the
plant must raise above to terminate an Auto Eq. cycle. Its default is the High Voltage Alarm
Threshold. The last setting in this sub-menu is the Auto Eq. Time, which is a timer from 0 –
10 hours that will terminate the Auto Eq. once the cycle has started. Its default is one hour.
A setting of 0 hours configures the Auto-Eq cycle to only terminate when the plant voltage
exceeds the Auto Eq. OFF threshold or premature termination point (above) occurs i.e. Auto
Eq. shut-off by HVA. Any high temp alarm will abort an Auto-Eq cycle while in progress.
Use the “
ESC
” and “
Next
” key to access the next menu.
3.8.9 Auxiliary Relay Sub-Menu
The Auxiliary Relay menu allows the user to define the Auxiliary relay as one of the
following: an extra Major or Minor alarm output, an Equalize alarm relay, an Audible alarm
relay, or any Alarm Condition output. If the user “
Selects
”
Alarm Cond,
any enabled
analog or binary channel's threshold is made available for the Auxiliary Relay trigger.
The user presses the “
Select
” key to enter the sub-menu, then “
Next
” to scroll through the
choices. Pressing “
Select
” at any point sets the Aux relay to “
Energize
” when an alarm
occurs. Pressing “
Select
” again changes it to “
De-Energize
” (FAIL-SAFE MODE) when an
alarm occurs. Pressing “
Select
” third time will disable the Aux relay. When the selection is
“
Energize
” or
“De-Energize
” all previous selections are disabled. Pressing “
Select
”
when
the
Alarm Cond
display appears sends the user to a listing of the enabled analog thresholds
and binary channels. The user presses the “
Next
” key to scroll through the choices, and the
“
Select
” key to pick one. After making a choice, press “
Escape
” to return to the top of the
Auxiliary Relay menu.
3.8.10 Backlight Option
The backlight can be configured to turn on only when a key is pressed or to always be on.
Pressing the
SELECT
key will toggle between “
ALWAYS ON”
,
“KEY ON”
, or
“OFF”
options. When the backlight is set to “
KEY ON”
the backlight will turn on when a key is
pressed and will extinguish after 5 minutes of inactivity. The light will also turn on when any
alarm condition occurs. The light will remain on until the alarm extinguishes. When set to
“OFF”
the backlight will always remain in the off state.
Use the “
Next
” key to access the next menu.
3.8.11 About PSMC
This menu indicates what version of software is in the PSMC unit. This information is
helpful when contacting Customer Support.
Use the “
Next
” key to access the next menu.
You can now press “
Next
” or
Previous
” to return to any
System Options
menu. When
completed, press “
Escape
” again to return to the top of the
System Options
where “
Next
”
or “
Previous
“ can be used to scroll to any
Configure
menu.
When completed, press “
Escape
” to return to the “
SELECT MODE:
” menu. Use “
Next
” or
“
Previous
” to reach other menus, or “
Escape
” again to return to the Idle Display.
