Specifications
1. AKU screwdriver
Voltage: 19,2V - DC
Free speed: 0 - 1600 rpm
Chuck: 1/2“
Dimension: 273x76x85 mm
Max Torque: 350Nm (m/- 10%)
Weight (with Battery): 3518g
2. Charger List
Input Voltage: 230V, AC
Output Voltage: 19,2V
Approval: CE
Charging Time: 60 minutes
3. Battery pack list
Voltage: 19,2V
Capacity cell type: 3,0 Ah Ni-Mh
1
3
2
4
5
6
1 Housing
2 Carbon brush
3 Shaft
4 Foward/Reverse handle
5 Switch trigger
6 Release button
7 Battery
8 Cord
9 Pilot lamps
10 Battery installation hole
11 Body
7
9
8
10
11
Removal and installation method of battery
How to install the battery?
Align the battery with the groove in tool handle and slip it into place. Always slide it all the way until it locks in place with a little click, If not, it may
accidentally fall out of the tool, causing injury to you or someone around you.
How to remove the battery?
Withdraw battery from the tool handle while pressing the latch on the top of the battery.
Charging method
1. Insert the plug of battery charger into the receptacle.
When the plug of battery charger has been inserted into the receptacle, there is no lamp will light. Before plugging
into the receptacle, make sure the following points. The power source voltage is stated on the nameplate and the cord is not damaged.
WARNING!
Do not charge at voltage
higher than indicated on the nameplate. If charged at voltage higher than indicated on the nameplate, the charger will burn up. Do not use the electrical cord if damaged.
Have it repaired immediately..