2. Installing a socket align the plunger located in the square part of the shaft/anvil with the hole in the square socket. Check
that the plunger is fully engaged in the hole. When removing the socket, reverse the sequence.
3. Removing the socket. Please do the opposite point on the method of installing socket.
4. Confirm that the battery is mounted correctly.
5. Check the rotational direction the socket or bit rotates clockwise (viewed from the rear side) by pushing the R-side of the
push button. The L-side of the push button is pushed to turn the bit counterclockwise. (The L and R marks are engraved on
the body.)
WARNING!
The push button can not be switched while the impact wrench is turning. To switch the push button,
stop the impact wrench, then set the push button..
button
6. Switch operation. When the trigger switch is depressed, the tool rotates. When the trigger is released, the tool stops. The rotational speed can be controlled by varying the
amount that the trigger switch is pulled. Speed is low when the trigger switch is pulled slightly and increases as the trigger switch is pulled more.
WARNING!
A buzzing noise
is produced when the motor is about to rotate; this is only a noise, not a machine failure.
7. Tightening and loosening screws. Install the socket or bit that matches the screw, line up the bit in the grooves of the head of the screw, then tighten it.
Push the impact wrench just enough to keep the bit fitting the head of the screw.
WARNING!
Applying the impact wrench for too long tightens the screw too much and can
break it. Tightening a screw with the impact wrench at an angle to that screw can damage the head of the screw and the proper force will not be transmitted to the screw.
Tighten with this impact wrench lined up straight with the screw.
8. Tightening and loosening bolts. A square socket matching the bolt or nut must first be selected. Then mount the socket on the anvil, and grip the nut to be tightened with
the hex socket. Holding the wrench in line with the bolt, press the power switch to impact the nut for several seconds. If the nut is only loosely fitted to the bolt, the bolt
may turn wit the nut, therefore mistaking proper tightening. In this case, stop impact on the nut and hold the bolt head with a wrench before restarting impact, or manually
tighten the bolt and nut to prevent them slipping.
Maintenance and inspection
1. Checking the condition of the socket or bit: The bits should be checked regularly. If worn or broken bits can slip or decrease the efficiency of the motor and burn it out.
Replace worn bits with new ones.
WARNING!
Pull out battery before doing any inspection or maintenance.
2. Checking the condition of the socket A worn or deformed a square-holed socket will not give an adequate tightness to the fitting between the nut or anvil, consequently
resulting in loss of tightening torque. Pay attention to wear of a socket holes periodically, and replace with a new one if needed.
WARNING!
If you use a driver bit of which point
is worn or broken, it will be dangerous since it slips. So replace it with a new one.
3. Check the Screws. Loose screws are dangerous. Regularly inspect them and make sure they are tight.
WARNING!
Using this power tool with loosened screws or nut is extre-
mely dangerous.
Use
Check the work area to make sure that it is clear of debris and clutter. Clear the area of unnecessary personnel. Ensure that
lighting and ventilation is adequate.
1. Install the socket or bit.
WARNING!
Make sure it is not coming off, if the socket or bit is lightly pulled. Push forward the bit
chuck on one side. If the guide sleeve does not return to its original position, then the bit is not installed properly.
push
trigger
