Union INCA1011, Original Operating Instructions, Page: 29 / 65

29
6 Startup /switching on
ATTENTION
To establish operational readiness, including of the linked system components,
according to the corresponding operating instructions.
NOTE
The following table includes abridged instructions for commissioning the system
after a longer standstill.
To turn on the process gas analyser after a short downtime, a few steps can be
omitted:

right column!
Steps Startup
Turning
on
Check whether the ambient conditions (

Technical Data chapter on
page 5 ! ) meet the requirements.
X X
Check that the process gas analyser has been fastened securely.
X
Check that the device is suitable for the process gas.
X
Check that the process gas is correct.
X
Check that the gas connections are correct and tight.
X X
Check the integrated filters (water/fine filter) for condensate, if necessary.
X X
Check, if necessary, that the calibration gas is correct.
X X
Establish/switch on the operator energy and media supply.
X X
Check the voltage.
X
Open shut-off valves.
X X
Turn on the master switch.
X X
Make sure the linked system components are ready to start.
X X
If the process gas analyser was only switched off temporarily,
production can be resumed.