25
UniNet iColor Printing Solutions
|
| www.icolorprint.com
SubliSlate
1)
Close the press to preheat the lower platen.
2)
Print the image using the iColor® Dye Sublimation Toner kit. Mirror Print.
3)
Place the substrate on the lower platen of the press (coated side face up). Align the printed image to
the substrate with the printed image on top (image facing the substrate). It is suggested you wrap the
transfer around the substrate and tape it securely. This will allow the edges of the substrate to accept
the transfer as well.
4)
Cover the transfer with copy paper or blow off sheets.
5)
Press at 380°F / 193°C with low pressure for 540 seconds (9 mins).
6)
Open the press slowly and peel immediately (hot peel).
7)
Cool substrate as quickly as possible.
8)
Clean excess toner residue with STC9 solution, or use a SubliClean sheet (recommended) during the
pressing stage.
Dynasub / Unisub Metals
1)
Close the press to preheat the lower platen.
2)
Print the image using the iColor® Dye Sublimation Toner kit. Mirror Print.
3)
Place the substrate on the lower platen of the press (coated side face up). Align the printed image to
the substrate with the printed image on top (image facing the substrate). You can tape the paper to
the substrate or lower platen for additional stability.
4)
Cover the transfer with copy paper or blow off sheets.
5)
Press at 380°F / 193°C with low pressure for 60 seconds.
6)
Open the press slowly and peel immediately (hot peel).
7)
Cool substrate as quickly as possible.
8)
Clean excess toner residue with STC9 solution, or use a SubliClean sheet during the pressing stage.
Coated Ceramic (Heat Press)
1)
Close the press to preheat the lower platen.
2)
Print the image using the iColor® Dye Sublimation Toner kit. Mirror Print.
3)
Place the substrate on the lower platen of the press (coated side face up). Align the printed image to
the substrate with the printed image on top (image facing the substrate). You can tape the paper to
the substrate or lower platen for additional stability.
4)
Cover the transfer with copy paper or blow off sheets.
5)
Press at 380°F / 193°C with low pressure for 150 - 180 seconds.
6)
Open the press slowly and peel immediately (hot peel). Dunk into warm water to stop the sublimation
process.
7)
Clean excess toner residue with STC9 solution, or use a SubliClean sheet during the pressing stage.
Ceramic Mugs (Mug Press)
1)
Print the image using the iColor® Dye Sublimation Toner kit. Mirror Print.
2)
Trim the image and align to the mug. Use heat resistant tape and hold in place. Be sure not to tape
over any part of the image or defects will result.
3)
Place the mug into the mug press and press at 380°F / 193°C with medium pressure for 150 - 180
seconds.
4)
Open the press slowly and peel immediately (hot peel). Dunk into warm water to stop the sublimation
process.
5)
Clean excess toner residue with STC9 solution, or use a SubliClean sheet during the pressing stage.