Body and Implement Mounting Guidelines U500 North America
Pneumatic Consumers
August 2005
Page 243 of
294
8.3 Air
extraction
The locations on Figure 8.2 and Figure 8.3 called air extraction
interface are detailed described on the following pages.
Note:
All connecting parts with thread must be mounted with
sealing compound Loctite Thread Sealant with Teflon
.
8.3.1 Air extraction on vehicles without CTIS
On vehicles without CTIS the L-fitting shown in Figure 8.2 and
Figure 8.4 must be replaced with all parts like displayed in
Figure 8.5. All necessary parts are described on page 247.
Figure 8.2: Vehicle without CTIS (back view)
8.3.2 Air extraction on vehicles with CTIS
On vehicles with CTIS dried air can be extracted behind a pro-
tection valve (part-no.: A005 429 55 44) at the ½ in interface
(see Figure 8.3). The air extraction can be realized like shown in
Figure 8.7.
Figure 8.6 shows the serial mounting parts on vehicles with op-
tion code A30
(CTIS). Connecting of additional pneumatic con-
sumers can be realized by retrofitting the serial parts with addi-
tional parts. An overview of the retrofitted interface is shown in
Figure 8.7. All necessary parts are described on page 247.
Figure 8.3: Air extraction interface on vehicle with CTIS
Wet tank
Purge tank
Reservoir circuit 1
(primary reservoir)
Air extraction
interface
Reservoir circuit 2
(secondary reservoir)
Air extraction
interface