Uniks ISO-5, Operating Manual

Page: 7 / 65

7
CHAPTER 2
USER AND BATTERY SAFETY
USER SAFETY:
Following safety measures should be taken while using the instrument:

The circuit under test should be turned off /denergized(dead), all its terminals should be
isolated, the circuit should also be discharged and checked before the insulation is tested.

During the test please make sure that you do not touch any of the test leads. The caution
symbol on the measurement screen indicates that hazardous voltage is present at the
test leads.

After test completion you should make sure that the load is completely discharged
because this charge can be dangerous.

The voltage indicator and internal discharge should be treated like additional safety
devices and not a substitute for the general practices.

Insulation testing in wet conditions can be hazardous. It is recommended that the
instrument should not be used under these circumstances.

During control from bluetooth or USB the test can be started at any time. Please make
sure the connections are proper before turning on the test.

Please use only the leads supplied with the meter for testing the device.
NOTE: INSTRUMENT SHOULD BE OPERATED BY SUITABLY TRAINED AND
COMPETENT PERSONS ONLY
BATTERY SAFETY:
Following safety measures should be followed while handling the battery:

Do not disassemble or change the battery. This battery consists of safety and protection
devices which if damaged can cause harm to the battery.

Do not heat the battery in any way.

Do not pierce the battery.

Do not expose the battery to water.

Do not subject the battery to shocks.