03
07 Solder on the MOSFET, notice the
orientation of the MOSFET marked by
a dot in the corner, solder the marked
resistors if you wish to install LEDs
100ohm
100kohm
08 Solder on the resistors on all the
switches (skip this step if you do not
need LEDs)
10 Reorient your PCB as follows
12 (Optional) Place sellotape onto the
location marked with a red rectangle
13 Orient the LEFT controller as follows
(Controller package should be marked
LEFT or RIGHT)
14 Place and solder the controller
as follows
09 Insert 2 leads cut from the diodes and
solder them by following the white
lines on the PCB
11 Solder on the TRRS jack, make sure
the TRRS jack is facing up and the
diodes are facing down
