Unigas S10, Installation Operation & Maintenance, Page: 12 / 32

PART I: INSTALLATION 12
SERVOCONTROL CAMS SETTING
Servocontrol cams setting
The setting procedure is the same for Berger and Landis servocontrols. Refer to the table below for the correct correspondence
of cams. Values in parenthesis shown the factory settings.
In the servocontrols BERGER STA6B3.41 e STA4.5, the manual air damper control is not provided. The regulations are carried
out by means of the appropriate tool fitted with the servocontrol (with SQN30) or by means of a screwdriver, affecting on the
screw into the cam (all other servocontrols).
Landis SQN30.151 Berger STA6B3.41
Fig. 15a Fig. 15b
Landis SQN70.224A20 Berger STA4.5BO.37/6
Fig. 15c
Fig. 15d
LANDIS
SQN30.151
BERGER
STA6BB3.41
LANDIS
SQN70.224A20
BERGER
STA4.5B0.37
ADJUSTMENT
(only with MB-DLE)
I ST2 RED I (70°) High flame 70°
II ST0 BLUE II (0°) Stand-by 0°
III ST1 ORANGE IV (10°) Low flame 10°
V MV BLACK III
Used only with
double stage
Multibloc
-
I
II
III
IV
MV
ST2
ST1
ST0
RED
ORANGE
BLACK
MAN - AUTO
BLUE
I
II
III
IV