Unigas RX63, Manual Of Installation - Use - Maintenance

Page: 10 / 127

PART I: SPECIFICATIONS
10
Checking the proper gas train size
Pressure in the Network / gas flow rate curves
z
Natural Gas burners
To check the proper gas train size, it is necessary to the available
gas pressure value upstream the burner’s gas valve. Then subtract
the backpressure. The result is called
pgas. Draw a vertical line
matching the furnace input value (600kW, in the example), quoted
on the x-axis, as far as intercepitng the network pressure curve,
according to the installed gas train (DN65, in the example). From the
interception point, draw an horizontal line as far as matching, on the
y-axis, the value of pressure necessary to get the requested furnace
input. This value must be lower or equal to the
pgas value, calcula-
ted before.
GAS PRESSURE
IN
THE NETWORK
mbar
RX63 M-..
Stm
3
/h
Caution: the gas rate value is quoted on the x-axis, the related network pressure is quoted on the y-axis
(pressure value in the combustion chamber is not included). To know the minimum pressure at the gas train
inlet, necessary to get the requested gas rate, add the pressure value in the combustion chamber to the value
read on the y-axis.
0
5
10
15
20
25
100 200 300 400 500 600 700 800 900
Potenza / Output (kW)
Minima pressione gas in
rete / Minimum inlet gas
pressure (mbar)
Rp 2" (50)
DN65
Power kW
mini
mum g
a
s pr
ess
ure
in
the
ne
twor
k
mba
r
DN65