Unigas LX60, Manual Of Installation - Use - Maintenance

Page: 14 / 116

PART II: INSTALLATION
14
MOUNTING AND CONNECTING THE BURNER
Fitting the burner to the boiler
To install the burner into the boiler, proceed as follows:
1
make a hole on the closing door of the combustion chamber as described on paragraph “Overall dimensions”)
2 place the burner to the boiler: lift it up and handle it according to the procedure described on paragraph “Handling the burner”;
3 place the 4 stud bolts (5), according to the burner’s drilling plate described on paragraph “Overall dimensions”;
4 fasten the 4 stud bolts;
5 place the ceramic fibre plait on the burner flange;
6 install the burner into the boiler;
7 fix the burner to the stud bolts, by means of the fixing nuts, according to the next picture.
8 After fitting the burner to the boiler, ensure that the gap between the blast tube and the refractory lining is sealed with appropriate
insulating material (ceramic fibre cord or refractory cement).
Packing
The burners are despatched in wooden crates whose dimensions are:
z
LX60: 1200mm x 670mm x 540mm (L x P x H).
z
LX65 - LX72: 1280mm x 850mm x 760mm (L x P x H).
Packing cases of this type are affected by humidity and are not suitable for stacking.
The following are placed in each packing case:
z
burner with gas train;
z
gasket to be inserted between the burner and the boiler;
z
envelope containing this manual.
To get rid of the burner’s packing, follow the procedures laid down by current laws on disposal
of materials.
PART II: INSTALLATION
H
P
L
Keys
1 Burner
2 Fixing nut
3 Washer
4 Ceramic fibre plait
5 Stud bolt
7 Blast tube