Administration
A31003-S2030-M100-11-76A9, 01/2015
214
OpenStage SIP V3R3 for OpenScape Voice, Administration Manual
administration.fm
Transferring Phone Software, Application, and Media Files
3.16.3
Phone Software
The firmware for the phone can be updated by downloading a new software file to the phone.
If an incorrect software image is being attempted to be loaded onto the phone, the phone will
reject the request and return to normal operation without reboot. As part of this security mech-
anism, new software binds are identified by a "Supported Hardware Level" information built into
the header.
Prerequisite: The phone knows its own hardware level (from the part number and/or by a dy-
namical check of its HW level).
When a new software bind is downloaded to the phone, the following verifcation is performed:
1. If new software bind has hardware level header included (in the bind header):
Hardware level of new bind is compared with phone’s hardware level
a) If compatible (or if Override is set): Proceed with update
b) If NOT compatible: Abandon update and return to original application
2. If new software bind does NOT have hardware level header included (in the bind header):
Software version of new bind is compared with minimum known supported SW level
a) If compatible (or if Override is set): Proceed with update
b) If NOT compatible: Abandon update and return to original application
3.16.3.1
FTP/HTTPS Access Data
If the default FTP/HTTPS Access settings (see Section 3.16.2, “Common FTP/HTTPS Set-
tings”) are to be used,
Use defaults
must be set to "Yes", and only the
Filename
must be spec-
ified.
Data required (in any case)
•
Use defaults
: Specifies whether the default FTP/HTTPS access settings shall be used.
Value range: "Yes", "No".
Default: "No".
•
Filename
: Specifies the file name of the phone software.
•
After submit
: Specifies action after submit button is pressed.
Value range: "do nothing", "start download".
Default: "do nothing".
7
Do not disconnect the phone from the LAN or power unit during software update. An
active update process is indicated by blinking LEDs and/or in the display.
