6
Registering the Repeater/charger
Registering the Repeater/charger is a separate process from
registering the handset. You can use the charger even if the
handset is not registered.
On the base, press and hold
11
FIND
when the phone is in standby1
21 On the bottom of the repeater/charger,
press and hold the registration
button until the
lINk
light starts to
blink (about 2 seconds)1
Release the button and wait for
31
the
lINk
light to turn on and steady
(this can take about 90 seconds)1
If the
lINk
light doesn't
turn on,
disconnect
the charger's AC adapter1 Wait about ten
seconds, then try these steps again1
Some important things to remember:
Only register one charger at a time1 If more than one charger
is in registration mode at the same time, they can interfere with
each other1
If you want to use the repeater/charger with a different base, just
register the charger to the new base1 The charger automatically
erases the link to the old base when it registers to the new one1
Only register chargers to one base at a time1 If more than one
base is in registration mode at the same time, you can't control
which base the charger registers to1
Placing the repeater/charger
Here are a few tips for placing your repeater/charger so that you get
the clearest signal and the maximum range:
Make sure you have good reception from the base1
Put the charger
at least 10m
away from the base or any other
charger1 (If you put the charger on a different floor from the base,
don't forget to allow 10m vertically, also1)
If possible, mount the charger on the wall1
